Icynene Home Energy Audit Nationwide

Icynene Home Energy Audit in Yorba Linda: What to Know First

We provide independent Icynene home energy audit in Yorba Linda, typically scheduling within 48 hours and completing most jobs same day. Our written price lands before any work starts - no exceptions - and every audit includes a blower-door test, thermal imaging scan, and a printed report with your home’s actual numbers, not a generic checklist. If you own an Icynene-insulated home in Yorba Linda and your energy bills have climbed, rooms won’t hold temperature, or you’re preparing to add insulation, this page is for you. Call (909) 323-1675 for a free estimate and we’ll read your current situation with you.

Call (909) 323-1675

How Icynene Products Fail - and How We Fix Them

• Icynene Classic Max (open-cell, 0.5 lb density) shrinks away from top plates in Yorba Linda’s 140°F attic peaks. The foam was sprayed tight to the framing in 2016 or 2017, but seasonal thermal cycling between winter lows and Bastanchury Road summer heat causes 3-5% linear shrinkage. We find the gap with a borescope, seal it with compatible low-expansion foam, then re-test with the blower door.
• Icynene MD-R-200 (medium-density, 2.0 lb) develops micro-tears at duct chases where flex runs vibrate against cured foam. This is a series-specific issue: the higher rigidity that gives MD-R-200 its R-value per inch also makes it brittle at dynamic joints. We don’t just patch over; we remove the torn section, install a vibration isolation sleeve, and respray with matching density.
• Icynene H2Foam Lite water absorption in crawl spaces after seasonal rains. Open-cell Icynene is vapor-permeable by design, but Yorba Linda’s clay-heavy soils wick moisture into encapsulated crawl spaces when the vapor barrier is incomplete. We test with a calibrated moisture meter, replace saturated sections, and correct the encapsulation detail - usually a missing seam overlap at the pier pads.
• Icynene Classic Max overspray blocking soffit ventilation in pre-2020 Yorba Linda installs. Crews trained during the spray-foam boom sometimes sealed intake vents to achieve a continuous blanket. We map the blocked soffits with thermal imaging, surgically remove the obstruction, and install proper baffles before any new insulation goes in. Seal the leaks first. Then insulate. The numbers will tell you whether it worked.
• Icynene MD-C-200 (closed-cell, 2.0 lb) delamination from OSB roof sheathing in south-facing Yorba Linda attics. The dark shingles on homes near Savi Ranch absorb enough heat to push sheathing past 160°F, exceeding the adhesive bond temperature of early MD-C-200 lots. We test adhesion with a pull gauge, remove failed sections, and reapply with current-formulation MD-C-200 rated for higher in-service temperatures.

Our Icynene Home Energy Audit Process

1. 1
   Call intake, live person. A real voice answers at (909) 323-1675 24/7. We book a 2-hour arrival window and text your technician’s name and photo the morning of.
2. 2
   Blower-door depressurization test. We install a calibrated fan in an exterior door and measure CFM50 - the cubic feet of air your home leaks per minute at 50 pascals of pressure. This is your baseline number. Most Yorba Linda homes built 1985-2010 read 3,500-5,500 CFM50 before any work.
3. 3
   Thermal imaging and borescope inspection. We scan every Icynene surface with a FLIR camera and inspect suspect areas with a borescope - a camera on a flexible probe - to find shrinkage gaps, delamination, or moisture intrusion without tearing out finished surfaces.
4. 4
   Written scope and price. Before any repair or additional insulation, you get a flat price, written scope, and written warranty. Haven Standard Clause 1: no work starts without it.
5. 5
   Air sealing first, then insulation correction. We seal top plates, can lights, and penetrations with compatible materials, then address any Icynene repair or augmentation. We do not blow new insulation over unsealed attic floors.
6. 6
   Final blower-door test and documented photo record. We run the blower door again, print your before-and-after CFM50 readings, and deliver a photo record of every accessed area. You leave with paper in hand.

What Icynene Home Energy Audit Costs in Yorba Linda

Most Icynene home energy audits in Yorba Linda run $280-$450 for a single-family home under 3,500 square feet. This includes the blower-door test, thermal imaging, borescope inspection where needed, and the written report.

What moves the price:

• Home size and complexity: Homes over 4,000 square feet or with multiple HVAC zones add $80-$150 for additional test points.
• Crawl space or encapsulated attic access: Tight spaces requiring specialized equipment add $60-$100.
• Icynene repair scope identified: If the audit finds shrinkage gaps or delamination requiring remediation, we price that separately with the same written-price-first rule. Most Icynene repairs in Yorba Linda run $340-$780 depending on accessible area and foam density.

Your estimate is free. Call (909) 323-1675 for an exact quote - we’ll read your home’s specifics with you.

Why Yorba Linda Homeowners Call Topside Attic Insulation Yorba Linda for Icynene Work

We’ve sealed and insulated over 9,000 homes since 2016, every one with a written price first and a documented record at close. On Icynene jobs, we carry current-formulation MD-C-200 and MD-R-200 in our Yorba Linda warehouse, plus compatible sealants for Classic Max repairs - no waiting on freight from Ontario or Chicago. Wes Okafor built this crew on the principle that a blower-door number beats a handshake promise, and we publish those numbers on every applicable job.

We also service Reflectix and other major brands, so if your home has mixed insulation systems, we don’t hand you off. The 365-Day Done Right Promise applies to all work: if it’s not done right, we make it right. Calls are answered by a live person, 24/7.

FAQs